Nearly all of the time, companies will spend lots of money to purchase their lift trucks. It is vital, therefore to take good care of your machinery to protect your investment into the long run. It is really a great idea to know the procedures that are undertaken during the care and maintenance of this piece of machine.
By starting up the forklift and listening carefully how it works is amongst the best ways to tell how good the engine is running. Like for example, if there are any misses or knocks, the machine is faulty and this must raise several issues. What's more listen closely for any squealing sounds that come from the belts as these noises will provide you with a lot of information.
When doing maintenance, some of the main parts you would have to pay attention to consist of the safety warning devices, horn, the lights, the gauges and the overhead guard. Any faulty components or burnt out light bulbs need to be replaced as soon as they are noticed. It is also vital to check the wiring.
When the above components have been checked thoroughly, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Every cell of the battery must be checked in order to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the equipment and after that change the filters. The fuel filters, hydraulic filter and the transmission filter need to be frequently replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change is done and the filters have been replaced, a visual inspection of the drive axle needs to be done. If there is a grease fitting on the axle make certain to apply some grease. Inspect the engine belts for any frays or cracks. If you find any, fix the issue accordingly. Then, check every other component of the machinery like the wheels. If any type of issue or fault is detected, be certain to address it immediately in order to make sure the machinery is working at its safest and optimum levels.